SBS modified bitumen waterproof membrane, its base materials are polyester felt, or polyester
3/4/5mm thickness SBS polyester reinforcement based modified bitumen PE/Aluminum foil/Sand/ Mineral surface torch applied roofing felt Root Penetration Resistance waterproofing membrane roll
|Place of Origin:||China|
|Thickness available:||3mm, 4mm,5mm|
|Width:||1m or customized|
|Length:||7. 5m, 10m, 15m or customized|
|Minimum Order Quantity:||100 square meters|
|Price:||FOB Qingdao USD1.00-5.00/sqm|
|Packaging Details:||Tape Plastic Bag|
|Delivery Time:||7 days after order confirmation|
|Payment Terms:||T/T, L/C, D/P, or others|
|Supply Ability:||4 million square meters per month|
SBS modified bitumen waterproof membrane, its base materials are polyester felt, or polyester felt reinforced with glass fiber, dipped and coated with SBS thermoplastic elastomer modified bitumen, both sides are covered with fine sand, mineral granular, PE film, aluminum foil.
1) Good waterproof performance.
2) High tensile and tearing strength, elongation and size stability which accommodates substrate movement and deformation.
3) SBS Modified Bitumen Waterproof Membrane is better for building waterproof with low temperature.
4) Anti-puncture and rooting resistant, fatigue resistant, anti-corrosion, mildew resistant and weather resistant.
5) Easily operate with hot-melting method.
Technical data sheet
|No.||Items||Class I||Class II|
|1||Soluble Conten (g/m2)||3mm||≥2100||-|
|Test||-||Not Flame||-||Not Flame||-|
|Test||Not flowing, not dripping|
|3||Flexibility under Low Temperature||-20℃, no crack||-25℃, no crack|
|4||Impermeability, 30 minutes||0.3Mpa||0.2Mpa||0.3Mpa|
|5||Tension Test||Maximum (N/50mm)||≥500||≥350||≥800||≥500||≥900|
|Test||Not crack, not apart|
|7||Oil Permeability (pieces)||≤2|
1) Roof and underground in industrial and civil buildings, wall, toilet.
2) Bridge, subway, tunnel, swimming pool, etc.
3) Waste landfill, sewage plant, irrigation system, etc.
Make sure the roof deck smooth, clean, and dry (moisture<9%), then apply the surface of roof deck homogeneously with a kind bitumen paint, till dry to start application.
1) Heating and melting method
Heat the polyethylene film of the membrane and roof deck surface by heating and melting method to be nearly melted (not flowing), then install the membrane fully bonded to the roof deck with overlaps of 5-10cm.
2) Cold adhesive method
Pour the cold adhesive homogeneously on the roof deck, then roll the membrane to install it to be fully sealed to roof deck.
By heating and melting method and by cold adhesive can be used in alternation in application as requested. After application, a full serious inspection is required to sure no air bubble, no fold, no falling away. ect.
Storage and Transportation:
1) Separate storage for different models.
2) Temperature should be below 50 ℃.
3) Avoid direct sunshine, rain, keep ventilated.
4) Do not piled horizontally, keep stand and not more than 2 floors.
Fuhua, one of the largest China manufacturers and suppliers, now brings you 3/4/5mm thickness sbs polyester reinforcement based modified bitumen pe/aluminum foil/sand/ mineral surface torch applied roofing felt root penetration resistance waterproofing membrane roll from its professional factory. Please rest assured to buy.
Taitou Industrial Zone, Shouguang City, Shandong Province, China